STEEL – HYBRID IDLER

Components and Materials

The Idler consists of the following components and material:

  • Roller - 4 mm Steel tube.
  • End cap / Bearing housing - 30 % Glass filled Nylon
  • Flinger - 30 % Glass filled Nylon with integrated labyrinth seal.
  • Bearings - 6205 2RS C3 (One on each side)
  • Shaft - 25 mm steel - Tin plated.

Range available: The idler are available in 127 mm and 152 mm diameter, Series 25

Product Sizes

ROLLER OD SERIES BEARING SEAL TIPE SHAFT OUTSIDE SHELL BEARING HOUSING
101,6 25 6205 2RS C3 Triple laberynth + flinger 24.98mm EN 3 SABS Steel 3.5mm Polyprop
127 25 6205 2RS C3 Integrated laberynth 24.98mm EN 3 SABS Steel 3.8mm Polyprop
127 25 6205 2RS C3 Integrated laberynth 24.98mm EN 3 SABS Steel 3.8mm Glass filled nylon
127 25 6205 2RS C3 Triple laberynth + flinger 24.98mm EN 3 SABS Steel 3.8mm Polyprop
127 25 6205 2RS C3 Triple laberynth + flinger 24.98mm EN 3 SABS Steel 3.8mm Steel MS0368
152 25 6205 2RS C3 Triple laberynth + flinger 24.98mm EN 3 SABS Steel 3.8mm Steel MS0430
152 30/25 6205 2RS C3 Triple laberynth + flinger 29.98mm EN 3 SABS Steel 3.8mm Steel MS0350
152 40 6205 2RS C3 Triple laberynth + flinger 40mm EN 3 SABS Steel 4.0mm Steel MS0500

Divider

The following standards are applicable for both the Steel and HDPE Idler:

SABS 1313 - Specifies the characteristics of conveyor belt idlers that have metallic or non-metallic rolls for belt widths of up to 2400mm and for belt speeds of up to 5.0 m/s.

BS 2050 - Specification for electrical resistance of conducting and antistatic products made from polymeric materials.

DIN 53505 - Testing of rubber, elastomers and plastics; Shore hardness testing.

SABS 653-3 - Steel tubes for non-pressure purpose: Steel tubes for rolls for conveyor belt idlers.

The Steel and HDPE Idler was added to our product range to enable Nylocomp to provide a service to our clients over the broader spectrum of Conveyors Idlers.

Please contact our office for a quote. Note the wear loss on the steel compared to the YIGA-P®

Image Gallery