YP – IDLER (UHMWPE)

The Yiga-P® Idler was designed with the following features:

  1. The wall thickness of the tube is 12mm
  2. 30mm Shaft is used instead of a 25mm. 18/22CF is available.
  3. Shafts are tin - plated, no poisonous fluids are discarded after the process. This process is environmentally friendly.
  4. 1 Bearing and 1 Labyrinth seal is used on each side. (6306 2RS for the 128 OD Idler) (6308 2RS for the 160OD Idler). Seal arrangement can be specified.
  5. No material build-up on the outside of the shell.
  6. End Caps are glass reinforced Nylon for strength and impact absorption. We extended the length of the end cap with 5mm. This means we now have 10mm extra length on the end caps.
  7. Reinforcement of the bearing housing on the inside of the end cap was doubled. This will specifically increase the ability to withstand impact and provide additional protection for the bearing
  8. Stationary Flinger, seals against the end cap, and protect the seal arrangement.
  9. The Yiga-P™ Idler, is the most cost effective idler on the market today.

Sizes Available

ROLLER OD SERIES BEARING SEAL TIPE SHAFT OUTSIDE SHELL BEARING HOUSING
128MM 25 6205 2RS C3 Triple laberynth + flinger 24.98mm EN 3 12mm UHMWPE Polyprop
128MM 30/25 6205 2RS C3 Triple laberynth + flinger 29.98mm EN 3 12mm UHMWPE Glass filled nylon
160MM 30 6205 2RS C3 Triple laberynth + flinger 40mm EN 3 12mm UHMWPE Glass filled nylon

Divider

Image Gallery